TempoTreadle
  • About TempoTreadle
    • TempoTreadle Introduction
    • TempoTreadle Components
    • TempoTreadle I and II - Differences
    • Videos: Weaving with TempoTreadle
    • The Home Screen
  • Preparing WIF Files for your Project
    • WIF Files - Requirements
    • Saving a WIF to your Micro-SD Card
    • Inserting and Removing Micro-SD Cards from the TT System Unit
    • Loading your Design
  • Setup for a Weaving Project
    • Video: Project Setup - Load Project -Threading
    • Thread Assist
    • Loom Settings for your Project
    • Treadle Array Settings
    • Mapping Treadles
    • Color Change Alerts
    • Checking your Tie-Up
    • Colors Used
  • Weaving With TempoTreadle
    • Video: Basics of Weaving with TempoTreadle
    • The Weave Screen
    • Unweave and Free Weave
    • Stopping a Weaving Session
    • The Sequence and Pick Counters
    • Calculating Picks Per Inch (PPI)
    • Interval Limits - Alerting when Length is Reached
    • Video: Setting Picks per Inch and Interval Limits
    • Woven Length View
    • Restarting a Project
    • Using the Keypad
  • Overview Video of TempoTreadle on an Ashford Table Loom
  • Beyond the Basics
    • Copy Treadle Settings From a Prior Design
    • Weaving in Table2 Mode
  • File Types on the SD Card
  • Format your MicroSD Card
  • System Settings - Error and other Tones
  • Auto-Load - Load WIF on Power Up
  • Installation and Tuning
    • Powering with the Extended Battery
    • Powering with the Slim Battery
    • Powering without a Battery (AC)
    • Setup Instructions - By Loom
      • Louet David 3
      • Louet Delta
      • Schacht Wolf (Pup, Baby, Mighty)
      • Louet Spring II
      • Ashford Table Looms
      • Leclerc Voyageur
  • Tune Array - Aligning the Sensor Array
  • Troubleshooting FAQs
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Beyond the Basics

Copy Treadle Settings From a Prior Design

Project Setup | Load WIF

PreviousOverview Video of TempoTreadle on an Ashford Table LoomNextWeaving in Table2 Mode

Last updated 1 year ago

Was this helpful?

At the bottom of the Load WIF screen, an option appears called "Copy Treadle Settings".

The default is "N"for No.

This is a useful feature if you are preparing to load a new WIF that you want to use the same treadle mappings and settings that you had set up for a prior WIF.

Be sure to first have the prior WIF loaded, then go into Load WIF and select your new WIF file on the SD Card. Before pressing the green Load button, change the "N" on this option to a "Y" for yes. Any mappings, treadle status and color change alert options will be automatically copied to your newly loaded WIF.