About TempoTreadle
Preparing WIF Files for your Project
Setup for a Weaving Project
Weaving With TempoTreadle
Beyond the Basics
- Copy Treadle Settings From a Prior Design
- Weaving in Table2 Mode
File Types on the SD Card
Format your MicroSD Card
System Settings - Error and other Tones
Auto-Load - Load WIF on Power Up
Installation and Tuning
Tune Array - Aligning the Sensor Array
Troubleshooting FAQs

Powered by GitBook

On this page

Was this helpful?

Powering without a Battery (AC)

PreviousPowering with the Slim Battery NextSetup Instructions - By Loom

Last updated 8 months ago

TempoTreadle is supplied with a long cable to use for plugging into a wall socket. We supply one end for for the socket. Shown in the picture is the US adapter, but any adapter, such as that used for a mobile phone, can be used for if using TempoTreadle in a country outside the US.