TempoTreadle
  • About TempoTreadle
    • TempoTreadle Introduction
    • TempoTreadle Components
    • TempoTreadle I and II - Differences
    • Videos: Weaving with TempoTreadle
    • The Home Screen
  • Preparing WIF Files for your Project
    • WIF Files - Requirements
    • Saving a WIF to your Micro-SD Card
    • Inserting and Removing Micro-SD Cards from the TT System Unit
    • Loading your Design
  • Setup for a Weaving Project
    • Video: Project Setup - Load Project -Threading
    • Thread Assist
    • Loom Settings for your Project
    • Treadle Array Settings
    • Mapping Treadles
    • Color Change Alerts
    • Checking your Tie-Up
    • Colors Used
  • Weaving With TempoTreadle
    • Video: Basics of Weaving with TempoTreadle
    • The Weave Screen
    • Unweave and Free Weave
    • Stopping a Weaving Session
    • The Sequence and Pick Counters
    • Calculating Picks Per Inch (PPI)
    • Interval Limits - Alerting when Length is Reached
    • Video: Setting Picks per Inch and Interval Limits
    • Woven Length View
    • Restarting a Project
    • Using the Keypad
  • Overview Video of TempoTreadle on an Ashford Table Loom
  • Beyond the Basics
    • Copy Treadle Settings From a Prior Design
    • Weaving in Table2 Mode
  • File Types on the SD Card
  • Format your MicroSD Card
  • System Settings - Error and other Tones
  • Auto-Load - Load WIF on Power Up
  • Installation and Tuning
    • Powering with the Extended Battery
    • Powering with the Slim Battery
    • Powering without a Battery (AC)
    • Setup Instructions - By Loom
      • Louet David 3
      • Louet Delta
      • Schacht Wolf (Pup, Baby, Mighty)
      • Louet Spring II
      • Ashford Table Looms
      • Leclerc Voyageur
  • Tune Array - Aligning the Sensor Array
  • Troubleshooting FAQs
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Preparing WIF Files for your Project

Inserting and Removing Micro-SD Cards from the TT System Unit

PreviousSaving a WIF to your Micro-SD CardNextLoading your Design

Last updated 1 year ago

Was this helpful?

To insert the micro-sd card, insert the micro-sd card with the metal strips down as shown below. Then push the card into the slot. Note that the card should be pushed straight in.

To remove the micro-sd card, place your fingers over the edge and pull it the card straight out. Note that there is no "spring action" on this device; simply pull to remove, don't push and pull.

The picture below shows the a Micro-SD card fully inserted. There will be a small lip (about 2.5mm) extending from the case.

Inserting the Micro-SD Card
Fully Inserted Micro-SD Card