TempoTreadle
  • About TempoTreadle
    • TempoTreadle Introduction
    • TempoTreadle Components
    • TempoTreadle I and II - Differences
    • Videos: Weaving with TempoTreadle
    • The Home Screen
  • Preparing WIF Files for your Project
    • WIF Files - Requirements
    • Saving a WIF to your Micro-SD Card
    • Inserting and Removing Micro-SD Cards from the TT System Unit
    • Loading your Design
  • Setup for a Weaving Project
    • Video: Project Setup - Load Project -Threading
    • Thread Assist
    • Loom Settings for your Project
    • Treadle Array Settings
    • Mapping Treadles
    • Color Change Alerts
    • Checking your Tie-Up
    • Colors Used
  • Weaving With TempoTreadle
    • Video: Basics of Weaving with TempoTreadle
    • The Weave Screen
    • Unweave and Free Weave
    • Stopping a Weaving Session
    • The Sequence and Pick Counters
    • Calculating Picks Per Inch (PPI)
    • Interval Limits - Alerting when Length is Reached
    • Video: Setting Picks per Inch and Interval Limits
    • Woven Length View
    • Restarting a Project
    • Using the Keypad
  • Overview Video of TempoTreadle on an Ashford Table Loom
  • Beyond the Basics
    • Copy Treadle Settings From a Prior Design
    • Weaving in Table2 Mode
  • File Types on the SD Card
  • Format your MicroSD Card
  • System Settings - Error and other Tones
  • Auto-Load - Load WIF on Power Up
  • Installation and Tuning
    • Powering with the Extended Battery
    • Powering with the Slim Battery
    • Powering without a Battery (AC)
    • Setup Instructions - By Loom
      • Louet David 3
      • Louet Delta
      • Schacht Wolf (Pup, Baby, Mighty)
      • Louet Spring II
      • Ashford Table Looms
      • Leclerc Voyageur
  • Tune Array - Aligning the Sensor Array
  • Troubleshooting FAQs
  • Additional Links
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Weaving With TempoTreadle

Using the Keypad

PreviousRestarting a ProjectNextOverview Video of TempoTreadle on an Ashford Table Loom

Last updated 7 months ago

Was this helpful?

There are a few places in TempoTreadle where you can change a number value. To change a value, select the field by pressing in the rectangular box; this results in a keypad to pop-up (shown below). The current value of the selected field shows at the bottom (in this example, 430). Pressing the delete key (“DEL”) will start removing digits from the right and pressing a number adds a number. For example, if you press “DEL” once followed by “5”, the number will change to 435. Once you have the value you want, press Enter “ENT” to save the value and return.