TempoTreadle
  • About TempoTreadle
    • TempoTreadle Introduction
    • TempoTreadle Components
    • TempoTreadle I and II - Differences
    • Videos: Weaving with TempoTreadle
    • The Home Screen
  • Preparing WIF Files for your Project
    • WIF Files - Requirements
    • Saving a WIF to your Micro-SD Card
    • Inserting and Removing Micro-SD Cards from the TT System Unit
    • Loading your Design
  • Setup for a Weaving Project
    • Video: Project Setup - Load Project -Threading
    • Thread Assist
    • Loom Settings for your Project
    • Treadle Array Settings
    • Mapping Treadles
    • Color Change Alerts
    • Checking your Tie-Up
    • Colors Used
  • Weaving With TempoTreadle
    • Video: Basics of Weaving with TempoTreadle
    • The Weave Screen
    • Unweave and Free Weave
    • Stopping a Weaving Session
    • The Sequence and Pick Counters
    • Calculating Picks Per Inch (PPI)
    • Interval Limits - Alerting when Length is Reached
    • Video: Setting Picks per Inch and Interval Limits
    • Woven Length View
    • Restarting a Project
    • Using the Keypad
  • Overview Video of TempoTreadle on an Ashford Table Loom
  • Beyond the Basics
    • Copy Treadle Settings From a Prior Design
    • Weaving in Table2 Mode
  • File Types on the SD Card
  • Format your MicroSD Card
  • System Settings - Error and other Tones
  • Auto-Load - Load WIF on Power Up
  • Installation and Tuning
    • Powering with the Extended Battery
    • Powering with the Slim Battery
    • Powering without a Battery (AC)
    • Setup Instructions - By Loom
      • Louet David 3
      • Louet Delta
      • Schacht Wolf (Pup, Baby, Mighty)
      • Louet Spring II
      • Ashford Table Looms
      • Leclerc Voyageur
  • Tune Array - Aligning the Sensor Array
  • Troubleshooting FAQs
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Weaving With TempoTreadle

Stopping a Weaving Session

When ready to take a break from weaving, always press the Home Icon in the lower right corner. Although progress is saved as you are weaving, this is an extra measure of safety.

If the System Unit is left powered on, a screen saver will appear in a few minutes. To go back to weaving, simply press anywhere on the screen and the screen saver will disappear.

For an extended break where you want to power off the system unit, simply turn the Switch to Off on the TempoTreadle II units. For the original system units, use either the cord with the button or disconnect from the battery or the AC plug.

PreviousUnweave and Free WeaveNextThe Sequence and Pick Counters

Last updated 7 months ago

Was this helpful?